Skip to content

LED Strip Dimmer, casing

As the installation is not so much visible, I did not have to pay much attention to the look of the case used for this project. To go quickly, I chose to use a compartmented screw storage case.

In this box, each piece of hardware is placed in a compartment. On the picture below, we can see:

  • The Power supply on the top. And then in the botom row, from left to right,
  • The Arduino
  • The Relay module
  • The connector block to manage the main line wire connections
  • The Mosfet module


Be First to Comment

Leave a Reply

Your email address will not be published. Required fields are marked *